Hi i am not surprised it goes a lot better, popular opinion amongst most of the diagnostic community is that the map and ait sensors should be changed every 50k and the oxygen sensor every 90k always done it on mine and it seems to keep the DPF problems at bay because all sensors are reading correctly, not letting the ecu make default settings which always come down on the rich side so it won
Ford Mondeo – (RoClickMag / Shutterstock) The most common signs of bad O2 sensor in Ford Mondeo are slow acceleration, loss of power, irregular idling, engine hesitation or jerking when accelerating, high fuel consumption, higher tailpipe emissions, foul odor from exhaust, check engine light illuminates, and sometimes stalling.I have discovered that when a code P2454 is stored, the powertrain control module (PCM) has detected a low voltage input signal from the circuit of the diesel particulate filter (DPF) pressure sensor that has been given the designation A. Only vehicles equipped with diesel engines should exhibit this code.
You will need to rotate the steering wheel. Click OK and turn on ignition (switch to position 2). Then rotate the steering wheel about 10 degree to left and right. Wait 3 or 4 seconds and Launch X431 V successfully reset steering angle sensor for Ford Mondeo! Visited 1 times, 1 visit (s) today. Ford.